How to protect and check to make excavator hydraulic crushing pliers more durable

Excavator hydraulic pliers are like a bloody mouth used to bite things, with its teeth can bite open the solid reinforced concrete buildings and rigid metal, etc., in order to achieve the purpose of cutting, crushing and demolition, work very efficiently, the efficiency of the crushing hammer is two to three times, quite domineering! Hydraulic clamp consists of clamp body, hydraulic cylinder, movable jaw and fixed jaw, rotary mechanism, the external hydraulic system for the hydraulic cylinder to provide oil pressure, so that the hydraulic crushing clamp movable jaw and fixed jaw a one to achieve the effect of crushing objects. The slewing mechanism can be convenient to work with a more suitable angle. It is the same as the installation principle of the hydraulic crushing hammer, the piercing pin hole of the hydraulic crusher clamp is connected with the piercing pin hole on the front end of the excavator, and then the pipeline on the excavator is connected with the hydraulic crusher clamp, and the installation is completed, so you can carry out the crushing operation.

　　Although the excavator hydraulic clamp has simple operation, high mechanical strength, but only in accordance with the safety regulations for use, in order to ensure its productivity. The following is a specific introduction to the excavator hydraulic tongs safe operating procedures, interested friends can come to attention.

　　1, excavator hydraulic clamp operators must be familiar with the structure, performance and use of equipment code.

　　2, before work should be hydraulic shear each important part of the inspection, keep the machine and the surrounding site clean, wire insulation is good.

　　3, the staff should daily check the excavator hydraulic shear shaft and locking screws, if found loose, should be adjusted in time.

　　4, no hand or any part of the body into the knife under the mouth or other rotating parts to avoid accidents.

　　5, the use of the machine found to be operating abnormally, should immediately stop the machine to check.